Not too long ago, I was in the exact same boat. I had to cut a shim about 0.6m in length, but I didn’t have the right tools. What did I do? The internet was my friend! After doing some research, I discovered the best way.
To cut long shims with a table saw, adjust its height, set the fence and then make a steady, slow cut.
This article will show you how to safely use a table saw to accomplish this task. It’s very simple and you can get your shim cut in a matter of minutes. These are the steps to follow!
Step By Step Guide
-
The fence should be placed approximately 1/41 cm from the blade. The fence should be placed directly below the blade. The blade should be running at the slowest speed.
-
Next, place a straightedge on top of the workpiece. The straight edge should be held against the top of the workpiece.
-
Place the blade on the straightedge. You must ensure that the fence is correctly set up. As needed, adjust the blade until it covers the entire width.
-
After the blade is adjusted correctly, flip the workpiece upside down and lower it into the workpiece. Slowly move your blade across the workpiece. The blade should not touch the straightedge.
-
After the blade has passed through the workpiece completely, lift the straightedge up and slide it forward. Continue repeating steps 2-5 until you have removed all material.
-
Once you’re done removing the material from the workpiece, flip it over and go through steps 2-6 again.
Safety Tips
These are safety tips for cutting long shims with a table saw.
- When using a tablesaw, always wear your eye protection.
- When cutting, make sure your fingers are away from the blade.
- To avoid kickback, cut the shims one by one.
- If necessary, use a push stick or another device to guide the shim through your blade.
- Do not force the shim through a blade. This can cause serious injury.
- Before you begin to cut, make sure that the shim is properly secured.
- To avoid the shim from breaking or splintering, cut slowly and evenly.
- To ensure a smooth, clean cut, use a sharp knife.
- To avoid injury, carefully remove the shim from the saw blade after it has been cut.
- Before you attempt to clean it or maintain it, always unplug it.
Conclusion:
This is it! Now you should be able to use a table saw to cut long shims. This type of cut is something you should try the next time. You can experiment with different widths or lengths until you find what works best for your project.
FAQ,s
How do you cut a foot shim using a table saw
A table saw is all you need to cut a foot shim. Measure the space between your table’s front legs and mark where those legs are on the backside. Next, secure the board to its base. Next, move the blade slowly around to remove excess. Finally, drill a pilot hole at the center of your board and attach it using screws.
How do you make a table shhim?
Table shims are used to increase the table’s height. There are many sizes and shapes of table shims. They attach to the table’s underside using nails or screws.
